Home About us Products Electromagnetic tech Contact us Blog
 
  Home >> products >> Electromagnetic Stirrer >> electromagnetic stirrer(EMS) for slab caster  
   
Electromagnetic stirrers are designed and manufactured to achieve optimum metallurgical quality improvements based on each customer’s specific plant and casting conditions. In order for KEMEIDA to submit a proposal for EMS that will best meet the requirements of a specific customer, it is important that the following questionnaire is filled out in as much detail as possible and returned to KEMEIDA together with the inquiry.

Electromagnetic stirrer (EMS) for slab caster

EM BRAKE: EMBR and FC Mould
M-EMS: EMS can be installed inside or outside the mould.
S-EMS: there are three modes: behind the rollers; inserting the rollers; roller type
EMS FOR SLAB CASTER
Installation Position of EMS for Slab Caster

M-EMS for slab
Two coils shall be installed along width direct between meniscus and side hole of outlet. Fed by triphase power, it will produce traveling wave field. It is mainly used for medium and thick slab with low casting speed

S-EMS for slab
* EMS behind the rollers
EMS is installed behind the rollers, in one side or each side. It needs little change of caster and installation is simple. It can be moved promptly when breakouts happen. Stirring freq: 0.5 ~ 5Hz.
* EMS inserting the rollers
Two coils are installed in each side of the curve. The head of EMS is small to insert between rollers and be near to slab. Stirring effect is good for its high efficiency and low energy consumption. Stirring freq: 6~ 20Hz.
* EMS of roller type
EMS shall be made with the same size of the roller, and placed of rollers, installed in each side of the curve. These two couple stirring rollers are of CrNi heat-proof stainless steel. It is simple to install EMS without limit of caster size. Stirring freq is 2 ~ 5Hz

M-EMS for slab M-EMS for slab
EMS of roller type
M-EMS for slab
EMS behind the rollers EMS inserting the rollers
 
Lifting Electromagnets
Electomagnetic Stirrer
Cable Reel
Separator
Magnetic Lifter
Tong Grabs
 
   
  COPYRIGHT 2006 KEMEIDA elECTRTIC